Cutting Facing Chamfering Machine
Circular Saw Machine
INDTOOLS Cutting Facing Chamfering Machine Model
|Electric motor is directly coupled to the reduction Gear Box through timing pulley & Belt and inclined cutter drive arrangement is mounted on Linear Guide Ways for vibration free cutting to optimize production and tool life.
|The Cutter feed motion is controlled by Ball Screw & Servo Motor.
|Single piece construction of cutter arbor with Gear Box shaft gives run out free rotation to the cutter.
|The saw speed is controlled by A.C. Frequency Drive depending upon the application and cutter details, automatically through PLC.
|The machine is equipped with Micro Mist Cooling arrangement as Standard Supply.
|For Pipe clamping, heavy-duty collect type job clamping arrangement is provided which is operated Hydraulically.
|Horizontal clamping arrangement is used on shuttle system to index raw material stock of desired length. The shuttle stroke is 1000 mm controlled by Ball Screw & Servo motor. Special feature is provided wherein for small piece cutting, shuttle vise remains clamped till it reaches the end position to optimize productivity.
|For Chamfering Head 1 & 2 Collect type hydraulically operated clamping arrangement shall be provided.
|After every cut, saw does not return back till bar stock and cut piece moves away from the saw so that cutter does not touch from side on return stroke to optimize tool life.
|To obtain good finish cut, magnetic particle clutch brake is provided on gear box.
|Sequential control of the machine is by intelligent PLC & Colour touch screen HMI.
|Operational parameters like Feed rate, load per tooth, Cutter speed, No. of cuts to be cut, Job size, Cut length etc can be pre programmed. PLC can store many cutting programs for quick setup.
|Machine has a facility to indicate cutting time, cycle time & No. of Cut completed.
|Auto Bar Loader suitable for 6000 mm long bars can be opted at extra cost.
|Screw type Chip Auger (Swarf Conveyor ) is provided as standard feature of the machine.
|Smoke / Fume is exhausted to atmosphere from cutting area by a high flow special fan.
|LED Light illumination is provided inside the cabinet where cutting is done.
|To avoid damage to the HMI screen, Mouse can be used for operation and programming.
|Remnant length i.e. end piece length up to 200 mm or 200+cut length is possible.
|Hydraulic Power pack is provided with built in tank feature for easy maintenance.
|Automatic programmable Oil Lubrication System is provided for moving parts.
Note: Change in feature/construction may be possible as it is continuous process of modification/development. Please get confirmation before ordering.